Competent and accurate machine shop services will ensure maximum performance, reliability and engine life. If equipped, remove the damper from the transfer case. Tighten the ring until secure. Push in on the plug as you unscrew it so you can feel when all of the screw threads are out of the hole and so you will keep the oil from seeping past the threads until you are ready to remove the plug. If not already attached, connect the sending unit. Driving too fast for conditions creates the possibility of loss of vehicle control.
Align the air bleed hole on the thermostat with the notch in the housing, which is also the 12 o'clock position Clean all mating surfaces thoroughly. Place a drain pan under the transfer case, remove the drain plug and drain the fluid. Anytime the torsion bar is disturbed, the ride height must be checked and adjusted. This can be done at any speed. Be sure and block the diagonally opposite wheel to prevent the vehicle from moving. The transmission control switch is located on the end of the gearshift lever.
On Ranger vehicles, the rear fuel tank strap has two connections which must be unbolted. However, the front driveline will remain engaged to the front wheels until the manual locking hubs are disengaged. Connect replace gasket if so equipped the exhaust pipe to the manifold, then tighten the attaching nuts to 30 ft. Move the slide latch away from the pivot shaft. You can put the gearshift in any of the several positions.
It is advisable to wash the windshield carefully with a commercial glass cleaner at least once a month. Local laws may require specific equipment such as trailer brakes or fender mounted mirrors. Carefully pry the ball bearings from the cage. Check the spark plug boots and the nipples on the distributor cap and coil. I have the 1994 ford ranger ford garage repair manual in my lap.
Extreme care must be used if a power washer is used to clean the engine. Connect the negative battery cable, start the engine and check for leaks. Refer to Fuel pump shut-off switch in the Index to find additional information. Remove the housing and thermostat as an assembly. Read and follow the instructions provided with the kit carefully, for installation of the child tether strap anchor. If a door is open or ajar, the horn will give two short chirps warning you that a door is open. Some engines use two standard hex head bolts to retain the regulator instead of the Allen®.
Disconnect the heater hose at the pump. For the removal procedures see the appropriate Section for you vehicle. Remove the snaprings that retain the bearing cups. Reach into the access hole and disconnect the wiper motor linkage clip from the motor shaft Remove the clip. Hood release handle While applying upward pressure on the hood, lift the hood latch handle located in the opening between the hood and upper portion of the grille near the center, to your left, as you face the front of the vehicle. Raise and support the vehicle safely.
Slide the clamps over the replacement hose, then slide the hose ends over the connections into position. Driving too fast for conditions creates the possibility of loss of vehicle control. However, if the transmission is not working properly, for instance, the transmission may slip or shift slowly, or you may notice some sign of fluid leakage, the fluid level should be checked. The numbers on the connecting rod and bearing cap must be on the same side when installed in the cylinder bore. The auxiliary shaft cover and cylinder front cover share a gasket. To install: Coat the threads with electrically conductive sealer and thread the unit into place. Place a jack under the axle.
Have the headlight adjustment checked as soon as possible by a reputable repair shop. Remember that some longer exhaust pipes may be difficult to wrestle out from under the vehicle if it is not supported high enough. Clean the area around the switch. No drag must be present on the axle. These should include a belt routing diagram which may reflect changes made during a production run. Windshield washer fluid and wipers checking and adding fluid. The features on the console — bucket seats.