Remove the quick fasteners and pull the panel upward. Install the filler bolt and tighten it to the 10 Nm 1. Move in direction b to turn off the starter choke. Rear axle boot × 2 each side 1. The speed limiter keeps the throttle from fully opening, even Do not operate at speeds too fast for your when the throttle lever is pushed to the maxi- skills or the conditions. To see if ShippingPass is right for you, try a 30-day free trial. Remove the oil cap from the side of the crankcase.
Pull outward on the area shown, and then pull upward as shown. Refer to this section each time a panel has to be removed or reinstalled. Turn off the and and remove the oil cap from the side of the engine and check the oil level. It is not acceptable proof of maintenance work. If any abnormality is noticed the following material. No issues when you shop with us , buy now and go riding! Other tire combina- Rear 27 kPa 0.
Inflate the tires very slowly and carefully. Consult a Yamaha dealer if you 1. Items under a pound typically ship 1st Class. All the torque settings and adjust them as neces- parts and accessories added to this ve- sary. Oil quantity: Periodic oil change: 0.
They should Beginners should get training from a certified then regularly practice the skills learned instructor. Look out for obstacles which could Improperly operating over obstacles. Rev the machine freely but do drive select lever into the park position, then not use full throttle at any time. Could cause you to react more slowly. Bring the machine to a stop by applying the brakes. Pause a few seconds before the next attempt. Turn the adjusting bolt until the throttle le- ver free play is 3—5 mm 0.
Operation with wet brakes after wash- 7. Install the oil filler bolt and tighten it to the Differential gear oil measurement specified torque. Pour four-stroke oil into the crankcase and replace the oil cap. Remove the coolant reservoir cap. Always turn the lever to this position when the engine is not running.
Open the throttle lever gradually and con- tinue to watch to the rear while backing. Tightening torque: Drain bolt: 6. No matter how small the order or how far it needs to go, ShippingPass provides unlimited nationwide shipping. Use no more than the following pressures when seating the tire beads. Remove the headlight bulb holder by turning it counterclockwise.
Otherwise, the transmis- sion may be damaged. Install the wheel and the nuts. Insert the panel projections in the numer- ical order shown in the illustration, and then push inward on the area shown. Have the spark plug tightened to the specified torque as soon as possible. A headlight bulb is hot when it is on and To raise the beam, turn the adjusting screw in immediately after it is turned off. Lubricate the inner cables and the cable ends. Main switch The engine can be started only at this position and the headlights and taillight come on when the light switch is on.
Tapered nuts are used for both the front 3. If the fuel tank is overfilled, fuel could spill out due to heat from the engine or the sun. Otherwise, the rubber seals may dete- riorate, causing leakage and poor brake performance. When checking the fluid level, make sure the top of the master cylinder reservoir is level by turning the handlebars. Before riding, check that the brake fluid is above the lower level and replenish when necessary. Never climb hills with excessively slippery or loose surfaces.
Tighten the wheel nuts to the specified torque. If the battery seems to have discharged, dren. Standard position: B A- Minimum soft E- Maximum hard 4-22. Use the electric starter to see if there is compression. If dust or water collects in this hose, empty the hose and clean the air filter element and air filter case. Con- sult a Yamaha dealer if the fuel system needs to be drained instead. Dismount on uphill side or to a side if pointed straight uphill.
Install the engine oil filler cap and tighten it. To install Place the panel in the original position, and then install the bolts. ReturnsReturns accepted within 30 daysCustomer SupportIf there is an issue with your purchase, please contact us before leaving feedback so we can correct the issue in question. The fuel cock has three positions. Move in direction a to turn on the starter choke.