The bulbs twist into the backside of the instrument panel. Unscrew those 4 screws and pull the cover out some and you will see that there are 2 turn signal harness attached to the back of the lens. The failure mileage was 104,000. Now you need to take out the Black, not gold screws, and pull out the instrument panel, also don't be afraid to give that a nice tug too,. Are there any recalls on these clusters? The light sensor works on resistance! Remove grille, and four screws from headlamp assembly. After a few days it started working normally again until last night. To get the bulb out of the harness, hold the harness and twist the bulb to the right or left and pull it out.
It is twice more bright than your original halogen bulbs. I had one do this. This will unattach the harness from the back of the lens allowing you to pull it out. The speedometer worked intermittently and displayed inaccurate speeds before completely failing. Remove the 2 screws at the top of the instrument cluster bezel or dress front cover , carefully pry out with a small screwdriver and set aside.
Two different brands of bulbs can vary enough to turn the sensor on even though the lites work! Note :The Longer wire is positive polarity,and Short wire is Negative Polarity. This Kit includes 50pcs to upgrade your Gauges back lighting. But time will only tell. When I came to a stop light the odometer read 50mph, even though I wasn't moving. I located the instrument panel illumination lights on my 1990 Nissan D21 Pick-up by removing the clear plastic panel that protects the gauges and pulling the instrument panel forward. This item have build resistor in it, If it doesn't light up, just flip it 180 degrees,The Longer wire is positive polarity,and another Short wire is Negative Polarity.
The vehicle was taken to a mechanic who replaced the brake lines. The vehicle was not diagnosed or repaired. Twist the bulb retainer to remove. There are several of them. The vehicle has not yet been taken to the dealer or a mechanic. I thought possibly the rain may have had something to do with it if moisture had gotten in to the electronics somewhere. The bulbs twist into the backside of the instrument panel.
I am having several problems with the instrument panel, speedometer not reading properly, temp gauge wrong readings. All other gauges worked fine. After resuming at approximately 25 mph, the speedometer displayed 75 mph. This item have build resistor in it, If it doesn't light up, just flip it 180 degrees,The Longer wire is positive polarity,and another Short wire is Negative Polarity. There are several of them.
The manufacturer was notified of the failure. I t's illumination area is much wider than the normal bulb. I also swapped out the ignition switch assembly too. After the shop returned the vehicle nothing was working on the cluster other than the turn signals and the check engine when you start it. The socket seems to get very hot and the bulb gets stuck in the socket so some force pulling it out may be nescessary Answer. The manufacturer was not made aware of the failure.
Now, with the panel in your hands, flip it over the its backside and marvel how cool it looks. There is one indented in the center, one to the right, one to the left. Change the other side too!! The current and failure mileages were 62,000. Remove headlight, to do this there are 2 L pins that hold the headlight assembly in place. This Listing is 100 pieces White upgrade T4.
Use rubbing alcohol to clean bul … b and a clean cloth to install new bulb. Note :This item have build resistor in it, If it doesn't light up, just flip it 180 degrees,The Longer wire is positive polarity,and another Short wire is Negative Polarity. When the contact turned off and restarted the vehicle, the speedometer went from 70 - 140 mph before he resumed driving. Package: 50Pcs Mini Bulbs White. On the bulb there is a little notch that will only allow you to turn it one way.
It is then easy to untwist and remove them. The contact stated that while driving at various speeds, the fuel gauge failed without warning. . It is tricky, so be carefull. Be careful not to damage the wire harness lo … cated at the back of the cluster. The current mileage was 98,000 and failure mileage was 60,000. The speedometer remained there after the vehicle was turned off and has not changed.
Thought it was something else, suggested ignition switch assembly. Take the bulbs to your auto store and get matching bulbs. The current mileage was 46,000 and failure mileage was 45,800. It's a little crowded, but not too hard to access. General Motors has a letter of intent on the instrument panel, but because the vehicle has exceeded the 70,000 miles specified in the letter, the contact was denied the repair. I called a local parts place and they said no matter what the vehicle has to go back into the garage for programming for a new cluster. Ok, then you unplug the wires to the h … eadlight switch, and then you do the same to the two plugs connected to the wipers.